Ask Experts Questions for FREE Help !
Ask
    drnkpunk's Avatar
    drnkpunk Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 14, 2012, 09:14 PM
    Trying to hook up pumps in hot tub
    I bought a spa pack for my hot tub. Have everything, blower pump board, everything I thought I would need. It's an older hot tub and have no clue the brand. (got it free) anyway I understand basic plumbing and the way it should work. Here lies the problem, I see the inlet from the skimmer box and the outlet but with the outlet there are 4 jet hoses that I have no idea what to attach to. Would those be for a separate circulation pump? I don't get it every diagram shows just the 2 " in and out. Not 1" jet lines with shut offs. So any ideas??
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Jun 16, 2012, 12:31 PM
    Why not go to a store where they sell this type of equipment and see how it's done? I would think that you drill through the side of hot tub and mount the jets with clear GE Silicone used to seal it up. It should be very basic stuff. Here is a video on how to do some of the work, and there are many more covering every stage: Looking for HOT TUB INSTALLATION ? Yes, HOT TUB INSTALLATION . It's all here! - YouTube
    Water jets: Water therapy and ThermoSpas hot tub and spas: How water jets, pumps and bubbling works - YouTube
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I hook up two submersible pumps from two separate wells to one tank? [ 22 Answers ]

I have two wells with two tanks. I have it set up so I can run each submersible pump separatly. Each pump has it's own pressure switch. I would like to remove the two tanks and replace them with one large tank. How do I set this up with both pumps going to one tank with one switch, and still run...

What causes breaker with bad GFCI to run controls but not pumps on our hot tub? [ 6 Answers ]

240V breaker with bad gfci(wouldn't do anything when you pushed test)runs the controls on the spa but won't power on the pumps. Relay just clicks. When I installed a new breaker with good gfci the breaker trips immediately. Any ideas as I'm ready to sell the hot tub and want it to work properly. It...

Can I tap into my 220 line going to my garage to hook up my hot tub? [ 2 Answers ]

Just a quick question.

Hook up hot/cold and drain on floor above current washer hook up [ 1 Answers ]

Currently have washer and dryer in the basement. Would like to hook up washer and dryer immediately above these in my garage. The current drain system to the washer and dryer does not have a vent, do I need to add one. If I run the drain for the washer in the garage can it be connected to the...

How do I hook up a hot tub to an electrical panel [ 3 Answers ]

How do I wire it up, what amp breaker do I need,

View more questions Search