Ask Experts Questions for FREE Help !
Ask
    rjboggs's Avatar
    rjboggs Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 30, 2012, 08:12 AM
    Installing 230v 12-3 wire for irrigation 2hp mtor
    I have a double pole 230v 20amp breaker to install in the box. I want to run it out to the lake and connect a single outlet with a switch.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    May 30, 2012, 08:16 AM
    You are going to need more wires, 1 way could be have a 4 circuit panel at the lake, 2 for thye pump, 1 for the receptacle.
    Is the single outlet and switch for a light(s)?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I wire 1ph 208-230v outlet [ 4 Answers ]

Have to wire outlet for commercial freezer unit. Needs 1ph 208-230v. Plug is 15A/250V. Do I run 2 "hot" leads from same phase and one N/G to round pin? Not sure how you get 208-230 from one phase? Thanks - SM

I am trying to wire a 230v 50amp stick welder to my dryer plug, is this possible? [ 2 Answers ]

The welder has 4 wires black,white,red and green. The dryer plug is 3 wire. The dryer receptacle is black, red,and white.please help!!

I have a VFD input 230V 28.5A... out put 230V 10A 3phase, what breaker & wire gauge? [ 4 Answers ]

I inherited a 1972 Unisaw 3hp 3Phase motor. I have a 30 amp breaker going to my detached garage with a sub panel of 4 15amp breakers. The VFD to run the saw has an input of 230V single phase 28.5amps (I am not sure if this is the correct amount of amps, seems kind of high) and an output of 230V...

Installing New Thermostat from 6 wire to 5 wire [ 2 Answers ]

I'm installing a new 5 wire progammable Hunter Thermostat. I have all but one of my wires accounted for. I RH and RC jumped together with R, W2 to W, Y to Y, and G to G. I do not need the "C" common blue wire as the new unit is battery operated, so I have this wire taped off. I have an orange...

Installing a 230v electircal switch [ 1 Answers ]

I am trying to install a 230 volt, 30 amp, electrical switch on a power washer power supply. I have triped the breaker many time with the installation I performed. I am looking for a schematic on how this switch should be wired properly. Any suggestions?

View more questions Search