Ask Experts Questions for FREE Help !
Ask
    bruins4877's Avatar
    bruins4877 Posts: 2, Reputation: 1
    New Member
     
    #1

    May 9, 2012, 05:48 PM
    Amtrol WX-202 Clicking
    Hello all,

    I noticed that my water pressure last week was surging, then going back to normal. I heard a clicking noise in my crawlspace where the water tank is located. It only clicks when the water is on and sure enough, when it clicks once the water pressure surges, when it clicks again it goes back to normal. The water tank is an Amtrol WX-202. I have no idea how old this tank is as I just bought the house 2 years ago. Anyone hear or know if this issue and is there something other than complete replacement than can be done? Is this a sign that it is about to fail?

    Thanks for any info.
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
     
    #2

    May 9, 2012, 07:02 PM
    The clicking you here is your pressure switch turning off and on. The surge is probably due to a waterlogged tank. You can check that by holding down the little air valve located toward the top for several seconds. If water comes out, the tank is bad and should be replaced. Your tank is a 20 gallon bladder tank. Buying a somewhat larger replacement tank would probably be a good idea.

    This link will tell you a lot more.

    Troubleshooting a bladder pressure tank
    bruins4877's Avatar
    bruins4877 Posts: 2, Reputation: 1
    New Member
     
    #3

    May 9, 2012, 07:34 PM
    Thanks for the reply. I will check that when I get home. I guess a new tank is in my future...

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bad Amtrol WX202? [ 8 Answers ]

Good evening. I have a Amtrol WX202. I noticed my pump coming on when no water was being used. I also noticed some air in the water lines in the past few days. I started watching the WX 202. It's a 30/50. It kicks on precisely at 30 psi and off at 50. With no water being used the pressure drops...

Amtrol purger vent cap- how tight? [ 0 Answers ]

I have a FHW heat system with an Amtrol air purger. On top of the vent there is a small plastic red cap. How tight should this cap be? Is it normal for a small amount of water to leak out of the vent when the cap is not tight? Last year I had the system serviced because water was leaking. The...

Pumptrol Square D seetings/Amtrol wx-203 precharge adjustment [ 3 Answers ]

So, at 3 am when I'm trying to sleep the jet pump clicks on just for a moment , then a few minutes later it clicks on again momentarily, repeat, repeat... This probably happens at other times as well, but it's not so annoying then; then I can ignore the problem. Also, sometimes the Pumptrol needs...

AMTROL WX-202 pressure switch location [ 2 Answers ]

Greetings. Any info gratefully appreciated. My well water pressure is running wild. I have an AMTROL WX-202 tank. The well provides plenty of water. However, the pump is turning on and staying on while pressure continues to rise. It shows no sign of stopping at 80 psi. Then I kill the power and...

John Deere L110 Clicking sound on start - new solenoid, still clicking! [ 1 Answers ]

Hi all, I cut my lawn, engine was running for about 2 hours. Stopped at neighbors house, cold beer, go to restart, just a clicking sound. Thought battery was dead, did a quick check, good voltage, hooked it up to a charger, good amps. Still clicking. I figure it's the solenoid, picked one up...


View more questions Search