Ask Experts Questions for FREE Help !
Ask
    louise oldfield's Avatar
    louise oldfield Posts: 1, Reputation: 1
    New Member
     
    #1

    May 4, 2012, 08:13 PM
    Sewer s bend toilet
    Hi I have a s bend toilet installed and have put in a sbend drianage in the four inch pipe right under tiolet , I have a proplem with the water raiseing in toilet bowl then going down slowly , sometimes leaving waste. Can you help.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    May 5, 2012, 05:11 PM
    Quote Originally Posted by louise oldfield View Post
    hi i have a s bend toilet installed and have put in a sbend drianage in the four inch pipe right under tiolet , i have a proplem with the water raiseing in toilet bowl then going down slowly , sometimes leaving waste. can u help.
    How long has it been installed? If it's a older installation I have a solution for you. Back to you, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toilet closet bend [ 1 Answers ]

I am trying to remodel a bathroom and would like to move my toilet to sit against an outside wall. Do people do this? I understand that I would have to put the water line up through the floor, but my concern is more the drain. Currently the toilets in my house drain down and backwards, but being...

Venting toilet with 1/8 bend? [ 3 Answers ]

Looking at the attached, I know an 1/8 bend is 22.5 degrees, does this mean the vent would be 22.5 degrees off center right? This configuration can utilize a clean-out and may serve as a vent for shower and vanity? What if I put in a wye just downstream from wye shown to pick up 2" from shower...

Ok to use rotor rooter if toilet has lead bend? [ 3 Answers ]

OK to use rotor rooter if toilet has lead bend? Some say lead is too easily damaged to take the rotor rooter action as the downstream blockage is cleared.

Should I replace lead bend of toilet? [ 1 Answers ]

I just had an expensive toilet job: replaced flush and water valves in toilet tank. Because bowl was leaking onto floor, plumber replaced rotten wax ring under bowl. When he flushed the drain pipe or lead bend pipe, he said that it must be replaced due to back pitch and cracked flange. He said...

Lead Bend Toilet Flange [ 4 Answers ]

I think I have a real problem. In a bathroom remodel the plumbers left a 4" lead bend with about 6 inches above the new floor height. The tiling contractor cut the lead bend even with the floor, (about 1/4 inch above the tile). I gather from other wuestions that I don't have enough lead pipe to...


View more questions Search