Ask Experts Questions for FREE Help !
Ask
    artoro's Avatar
    artoro Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 15, 2010, 09:31 PM
    How to find TDC on a 1991 honda accord
    I removed the distributor and the wires ,now is all messed up,how do I find TDC and the firing order,how to set this straight again? Thanks
    thejohnlennon1's Avatar
    thejohnlennon1 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Apr 30, 2012, 10:48 AM
    The firing order on a 90-93 accord as far as I have seen because I have a 92 accord is 1-3-4-2 the wires set from front of engine also the tdc can be checked by removing spark plug 1 and placing a long screw driver or the oil dipstick and checking to see whrn it stops. Also on the driveplate in frontbof the engine there are several marks. I believe it has to be aligned with the white mark. Unsure about the last part
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Apr 30, 2012, 10:57 AM
    The following is Generic, good for Most:
    Have someone crank engine with cap removed to determine direction of rotation.
    Verify Firing Order.
    If you use the dipstick in the plug hole to find TDC. You could be 180 degrees out, due to the fact you need to be TDC on Compression Stroke.
    In that case, if it doesn't work, swap adjacent wires(if it was on exhause stroke, it will now be compression stroke), should work if you are close.
    Why did you remove the distributor?
    I would also buy the service manual if you like and plan to keep this car, It will save you money and Time, if you or someone else works on the car.
    Good Luck.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #4

    Apr 30, 2012, 11:05 AM
    Cylinder #1 is where the alternator is.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1992 Honda Accord TDC Sensor [ 6 Answers ]

I have a 1992 Honda Accord LX 2.2L sedan with an annoying little problem. The check engine light is on and the motor will absolutely not rev past 3500RPM despite the fact that it should be able to hit 6500RPM during hard acceleration (passing cars, fast 0-60, etc.) and exceed 3500RPM at speeds...

1997 Honda Accord TDC code [ 7 Answers ]

I changed the head on my motor. Timing belt was replace with a new one. Put everything back together and cranked it. Didn't want to crank over so found out my timing was off by 3 teeth. Redid and car started but rough. When reversing car tries to turn off. Then when driving, it drives okay but when...

TDC Timing Marks for 1987 2.0 Honda Accord [ 3 Answers ]

I'm having troble locatong the correct timing mark on the crankshaft of my Honda. Can somebody offer me some helpful hints and or advice

1991 Honda Accord [ 1 Answers ]

My 1991 Honda Accord EXR seems to have a problem with the torque converter not locking up. You can tell because at 100k the RPM is at about 3000rpm and once the car gets warmed up (about 1/2 hour of driving) the RPM drops to about 2600rpm and you can tell the converter is locked in. Any ideas of...

View more questions Search