Ask Experts Questions for FREE Help !
Ask
    ynotsocha1's Avatar
    ynotsocha1 Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 7, 2012, 02:01 PM
    Knowing if furnace thermostat is working
    I have a very old Tappen forced air gas furnace, I have never had a problem with. This morning when I turn on the thermostat I get no heat or forced air, even though I can hear the thermostat click when I raise the temp. Do you think it's the thermostat or furnace ?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Apr 8, 2012, 05:19 AM
    Pilot light or ignitor could be bad. Gas could be off.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Knowing things will happen before they do. Knowing the truth about a person good/bad. [ 3 Answers ]

I have this ability of seeing things good/bad before they happen. I can read a person without ever knowing the person. I get these feelings good or bad with in a very few minutes. Im very good at knowing someone better than they may know themselves. Even at meeting this person for the first time. ...

Our furnace stopped working. Circuit breaker OK, new fuses,no power to thermostat [ 1 Answers ]

The furnace just stopped. We checked the circuit breaker, it's fine, replaced fuses, all wiring is tight. The transformer is buzzing so I guess that means there is power, we replaced the thermostat, but there is no power to the thermostat. Any ideas?

Thermostat not working on wood furnace [ 0 Answers ]

I have an old wood furnace that I use for heating our home. Recently it has been acting funny. There is a switch on it where you can turn it on to blow air into the stove to get the fire going and then on the other side of the switch it has auto where the inside theromstat controls it. Well so you...

New Honeywell Thermostat for Heat Pump and Gas Furnace - not working [ 5 Answers ]

We recently bought a Honeywell RTH7400 for our home with a Goodman cple30-1 Heat pump and a Janitrol Gas furnace. I hooked it up according to the Honeywell instructions. C to C G to G Y to Y O to O/B R to RC with jumper to R W2 to Aux with jumper to E I set it to 7 on function 170...

My furnace or thermostat is not working [ 1 Answers ]

I have a honeywell RTH230B thermostat and my furnace is a carrier. Now the red light at the bottom of the furnace is on all the time when it works but then it will stop working and the red light will blink one short 4 long witch means it's a lockout. Now why does it do that and what do I need to...


View more questions Search