Ask Experts Questions for FREE Help !
Ask
    towandabp's Avatar
    towandabp Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 24, 2012, 11:23 AM
    Bryant model 350m error code 21?
    I've had an intermittent problem with my Bryant 350MAV for a couple of years. The motor will kick on but then it will just run. After a while I realize that it's getting cold in the house, the motor s running but I never heard the whoosh of the gas igniting. I pull the panel and see that it's flashing error code 21. I had the techs out several times and they just wiggled the wires and told me it was fixed. The last few times it has happened I just turned off the furnace and wiggled the wires myself and when I turned it back on the LED would be a steady glow and it would generally work for 3 more months or so before it failed again. But this time that didn't work. I've turned it off at the thermostat, turned it off at the switch on the furnace and cycled through that several times. It is totally ignoring any command sent from the thermostat, and when I turn off the switch at the furnace and wait a while then turn it on it immediately flashes code 21 and the motor just runs. My comfort level stops at wire wiggling, so I'm just wondering what to tell the tech when he tells me that the circuit board is bad and needs to be replaced for hundreds of dollars.

Check out some similar questions!

Bryant furnace model 376cav, error code 24. [ 7 Answers ]

I am getting error code 24 on my bryant furnace. Could someone please help me by letting me know what the code is, and how to fix it? I was trying to install a new thermostat and might have got wires crossed. Thanks

Bryant Plus 80 Error code 33 [ 3 Answers ]

Hello! I'm new on here so bear with me. I found a similuar post on the Bryant 80 but I believe I have a different model... not sure how much that matters. The only model number I could find on the unit was CK5AXA036017AAAA The Error code is 33 Limit or flame roll out switch is open. The furnace...

Bryant furnace model 310AAV blowing cold air, error code #13 [ 1 Answers ]

I have a Bryant furnace model 310AAV that is displaying the #13 error code. The furnace is blowing cold air... I've flipped the power and gas off a couple times and now I'm letting it run. Code #13 says after 3 hours the control will auto reset... does this mean if I leave it running for 3...

Bryant 352MAV and error code 12 [ 0 Answers ]

I have the Bryant 352MAV 2-stage furnace that is giving me problems: When the thermostat is set below the target temperature i.e. 19C/68F the LED code indicator (on the logic board) is steady ON, once the target temperature is set i.e. 24C/78F , the inductor motor comes on for perhaps 15 sec, then...

Bryant plus 80 error code 31 [ 1 Answers ]

Bryant Plus 80 furnace - Error code 31 What are the corrective measures to put this furnace back to producing heat? There is power, the fan works but there is no heat. We lost power recently but it worked after that. Last evening there were high winds which were indicated on the code...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.