Ask Experts Questions for FREE Help !
Ask
    cbcwright's Avatar
    cbcwright Posts: 4, Reputation: 1
    New Member
     
    #1

    Mar 17, 2012, 11:14 AM
    Replacing PVC with metal
    I have a drain pipe coming from the main floor of the house from the kitchen sink and garbage disposal that is PVC going into a silver/grey metal pipe in the basement floor. I have to replace the connection from the PVC to the metal pipe. Can I use Pipe Dope or pipe cement when I screw in the 1 1/2' PVC male adapter into the metal pipe?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Mar 17, 2012, 11:25 AM
    I assume the silver/gray pipe is galvanized iron with female threads Correct?
    Can I use Pipe Dope or pipe cement when I screw in the 1 1/2' PVC male adapter into the metal pipe?
    I would use Teflon Tape on the threads and PVC primer and cement on the PVC connection. Good luck, Tom
    cbcwright's Avatar
    cbcwright Posts: 4, Reputation: 1
    New Member
     
    #3

    Mar 17, 2012, 11:31 AM
    Yes it is galvanized but the threads inside are not real good. Thanks for your help
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #4

    Mar 17, 2012, 11:59 AM
    Use three wraps of Teflon Tape. Good luck, Tom
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #5

    Mar 17, 2012, 01:13 PM
    Yep, follow Toms advice. Teflon tape on plastic threads. Just clean the galve female threads up as best you can beforehand. Maybe even best to go as far as getting a thread cleaning tap/die.
    Attached Images
     

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

J-Pipe leaking where PVC meets metal ? [ 1 Answers ]

In my kitchen I have replaced everything with PVC, for the most part, and it's working fine. I am having issues where the J-pipe (PVC) meets metal. I am leaking there despite many attempts at re-seating the pipe and trying again. It is a very difficult connection, and turns hard. It takes a...

Am replacing metal roofing on bay windows Can shingles be placed over metal roof? [ 3 Answers ]

Metal is not copper. Also, does anyone know what the overhang should be (for shingles on bay window roof). Thanks

PVC or Metal conduit into a subpanel? [ 4 Answers ]

Hello, I'm installing a 200 amp subpanel in my barn, and am using 2" PVC conduit (buried) from the house. As I was going into the barn, I got to thinking that perhaps metal should be used above ground (in the wall feeding the panel). I would prefer to use the 2" PVC, all the way, but was...

Metal to pvc [ 3 Answers ]

Can you install brass or other metal pipes directly to a pvc fitting more specifically a male metal fitting into a female pvc fitting?

Metal 2 pvc is there a way [ 2 Answers ]

I'm trying 2 install a water filter off my water line coming into the house. They tell me it needs to be installed before it goes any farther than when it comes in the house. The problem I'm having is the house is all metal screw pipe. The big question is will pvc glue to it or screw to it or any...


View more questions Search