Ask Experts Questions for FREE Help !
Ask
    bajaexpl's Avatar
    bajaexpl Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 10, 2012, 09:13 PM
    Janitrol furnace inducer motor starts, burners start then shuts down
    It is a GMP-125-4
    Inducer motor starts, I can see the igniter glowing and all the burners start for a few seconds.
    Then it shuts down the status light on the control board goes out.
    If I restart the furnace again right away the burners only light for a split second
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Feb 11, 2012, 05:13 PM
    Clean or replace the flame senser
    bajaexpl's Avatar
    bajaexpl Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Feb 11, 2012, 06:04 PM
    Thank you but I already cleaned the flame senser. I replaced the controller board and that solved the problem
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #4

    Feb 11, 2012, 06:17 PM
    Just glad you got it fixed. Good job.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Draft inducer starts to rev up, but then shuts down [ 0 Answers ]

Hi everyone, I've got a bit of a problem with my furnace. First and foremost the problem... furnace won't start automatically, so I switch the fan to "ON" let it power up, then switch back to "AUTO" wherein the draft inducer will start up, run for about 5 seconds, then shuts off Now here's a...

Motor starts but miller furnace will not fire then motor shuts off a off [ 3 Answers ]

Motor starts but miller furnace will not fire then motor shuts off

Central heater furnace starts and blower starts for 30 minutes and then fan shuts off [ 1 Answers ]

We start our central heater and the furnace kicks in and then the blower starts and the house warms up but when it reaches the desired temperature. When the temp. drops and you can hear the furnace start but the blower will never kick in. If we shut off the whole thing and wait about 1 hour, we...

Janitrol Furnace issue motor would not start and pressure switch stuck closed [ 4 Answers ]

Hi I got this Janitrol Furnace it worked fine. Until my basement flooded then it looks like the circuit board got wet and it was on at the time. So basically I ordered a new board suppose to be coming soon. What happened was when the furnace came on like there were no flames only a bright...

Inducer motor starts running, but ignition never starts [ 1 Answers ]

I have a Payne Gas forced air furnace, and it's behavior has changed in the last couple of days, where it never gets past the Inducer motor cycle. When we turn on the thermostat (or even jumper across the "R" and "W" leads on the furnace controller) the inducer motor starts running and keeps...

View more questions Search