Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Troubleshooting rheem blower motor
[ 3 Answers ]
I have a Rheem air handler. The blower motor won't turn on right away. Massive humming sound. Through the service panel I can reach in with a stick and push it then it spins up and then runs fine. I took the unit out and inspected and cleaned the motor which seems fine. I am thinking it may be a...
Rheem Furnace Blower Stays On
[ 2 Answers ]
I have a Rheem Criterion II (Model RGPH 07NAMGR) with the main furnace blower that runs continuously. The IFC board (62-24084-82) is giving me the three blink error (middle green light between a green and orange bulb) which I believe indicates an open limit switch. I have check the three limits...
Rheem Classic 90: blower not starting?
[ 1 Answers ]
Furnace burner fires and runs for a few minutes until the limit switch shuts it down, and fault LED starts indicating "limit switch open". At no point during burn does the blower start. Find no line voltage across terminals N-H, N-C, or N-HC at anytime during the burner run.
Rheem blower motor keeps running
[ 2 Answers ]
... rheem criterton 2 rgph 10eamer... 100,000 BTU... 80%... 8 years old with the thermostat off the fan stays on all the time... also... no heat... not fireing and so because its not fireing the gas don't come on... please... if you can help... thanks very ...
Rheem Criterion II blower won't stop
[ 4 Answers ]
I have a Rheem furnace and the low speed fan continues to stay on after the furnace has cycled off. When I disconnect the red wire (low speed wire), the furnace runs normally. I would imagine the switch for the low speed is open. Is the switch controlled by the IFC? Does the IFC need to be... View more questions Search
|