Ask Experts Questions for FREE Help !
Ask
    denisenjim's Avatar
    denisenjim Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 29, 2012, 02:34 PM
    Resetting relay switch
    How do I reset the relay switch on my furnace to blow heat instead of cool air?
    baileeboy's Avatar
    baileeboy Posts: 8, Reputation: 1
    New Member
    		  
    #2

    Feb 19, 2012, 03:03 AM
    Generally every house should have a power box grid or the unit your using might have one of these find it and you will probably find a command switch to change the coolness of the air coming out the unit.

    Hope it helps

    B.Mason
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing fan motor relay switch with upgraded switch [ 4 Answers ]

Hello, I've searched online to locate a replacement fan motor relay switch for an old Fedders propane heating unit in my greenhouse. The replacement should be fairly easy to do, however the part I was needing ( RBM 84-20103-301A) was listed as obsolete and was replaced by (McQuay part #...

Do I need a new relay switch [ 1 Answers ]

I have installed a new sprinkler pump flowtec 220volt ,when the timer kicks on the relay switch clicks but there is no juice at the pump is the relay bad? Thanks bill

Resetting the ECM and Testing the Main Relay [ 1 Answers ]

I keep seeing people telling you to disconnect the negative terminal to clear the ECU. This is a poor choice and will result in having to reset the radio presets and the clock. Simply go to the main fuse box located on the passenger side inner fender. Remove the 15amp fuse in position 37, the...

Resetting a water pressure switch [ 1 Answers ]

The power surged off and on this afternoon and the pressure in my water pressure tank dropped to 0. There is no reset lever on my water pressure switch and the Franklin Control for my submersible pump is switching on and off every 9 seconds or so. Any help would be very appreciated!

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

View more questions Search