Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Painting cement block shower
[ 3 Answers ]
How do I clean and repaint a cement block shower that is used daily. It has mildew And the paint is chipping off. Also, what kind of paint should I use. Thank you.
How do you install an iron lintel in a cinder block wall after cutting the wall open?
[ 0 Answers ]
I plan on cutting & opening 7' tall x 8' wide in an existing cinder block wall 8"x8"x16" that was laid with a stack bond (joint on joint). How do I insert an iron lintel 1/2" thick x 4" wide x 8'6" length? The length of the lintel is planned to go beyond the width 3" on each side. Is that enough...
Repairing a block wall with poured wall
[ 1 Answers ]
Just purchased a 1940's cape house with clay soil and very poor drainage knowing these problems. No below grade outlet for footing drains. The front porch was solid concrete and settled over the years and poured water down between the foundation and the steps. It washed the grout out of the cinder,...
Pouring a concrete wall in front of a damaged cinder block wall
[ 1 Answers ]
I need to repair a well house that has buckling cinder block walls. The well is below ground with a shed above it. The room is approximately 9' x 8' and 8' tall with cinder block walls and a concrete floor. The block did not have concrete poured in it when it was built, the blocks are beginning...
Repairing and painting Block Foundations
[ 2 Answers ]
Power washing my block foundation to remove old peeling, flaking paint has left pock marks and some loss of mortar in joints. How do I repair and then what type of primer paint should I use? (Don't know what the original paint was-oil based or latex). I'd appreciate your help. Thanks. View more questions Search
|