I have a 89 civic si hatch with a b16a swap not starting I think wires are messed up

pitbullscott Posts: 26, Reputation: 1

New Member

Jan 15, 2012, 08:27 PM

I have a 89 civic si hatch with a b16a swap not starting I think wires are messed up

89 si dizzy bearing went out so I got new 1 its still throwing the dizzy code all the wires are are just messed up looking and I was wondering when swapping these motors what wires need to be wired up I thought the b16 was a perfict swap I need dizzy wiring diagrams
For the 89 si harness and were the dizzy wires on a b16a go

Check out some similar questions!

Civic hatch [ 1 Answers ]

I had problems with my civic stalling after turning it on and it running rough but I fix the stalling it stills runs a little rough it gave me code 16 (injector) but it turned out to be it was missing the clips on 2 of them so I fixed that problem but now it still runs a little rough and it tops...

91 civic hatch no start [ 2 Answers ]

My 91 won't start can ran OK but had a rough idle at stop so I took out injectors and cleaned with cab and choke cleaner replaced as instructed and it won't start fuel pump coming on getting gas to carb getting spark and not showing any error codes some assistance with this matter would be greatly...

94 civic hatch dx only getting about 24 m/gallon [ 1 Answers ]

I was getting about 35-37 a couple months ago, but then my car stopped working. I replaced the entire distributer, plugs, wires, fuel filter, fuel injectors, and PGM- FI Main relay. My car works now! Yay. (it still has a little trouble turning over, but it always does) Anyway, I am getting...

Honda civic swap to b18b won't start without starting fluid and sometimes stop running [ 1 Answers ]

I have a 92 honda civic dx that was swapped to a 94 b18b. The car ran fine for about 2 years and then started having startup problem. It doesn't matter when the engine is hot or cold, most of the time I have to use a starting fluid to get it start. Some time while driving, the car would just...

92 honda hatch w/ ls vtec swap problems starting [ 1 Answers ]

Ok so I have a problem with the car not starting because I am not getting any spark... I have checked the distributer, and all the wires are measuring out right with the right readings... So what we were thinking that it might just be the ECU but I don't want to get a new one because I have been...

View more questions Search

Check out some similar questions!

Add your answer here.