 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman furnace troubleshooting?
I have a goodman mid efficiency furnace that was installed in my house in 2007. I have to clean the heat sensor in it about 2 to 3 times a year. I was told by a technician that this is normal for these furnaces. But even after I clean the sensor, the furnace still seems to run all the time (a little less then it does with a dirty sensor). It will run for a few minutes, then it is only off for about 2 minutes until it clicks on again. I had it serviced in the fall and was told that everything was up to par, so why does it keep running? My utility bills are out of control!HELP!
|
||||
Check out some similar questions!
How can you tell if your heat exchanger is bad? I am getting high Co2 reading. And the flames seems to be blowing to strong, or could that be the gas valve, or dose it need adjustment in the tudes? I don't think the chinney is plugged.
I have a goodman furnace model # gmh80703ancb it is only 3 years old. The unit itself works great but the blower isn't working. Is there something I can do to check it before calling to get it serviced? Its getting cold, please help
Goodman 95% 2 stage furnace. LED code says pressure switch is stuck open. 1) Changed switch. 2) Jumped Limit switch. 3) Changed PCB. Same error code. 3 blinks "code says pressure switch is stuck open" Can You Guide me further
The flame sensor keep burning out and only run for a couple of minute . Maybe the condensation trap is fully of dirt
I went away for a couple of days and returned to a cold house. I have a Goodman Model HCC075ND4R that has Electronic Ignition with Relay + VR80204 - S8600H Control. I can not get it to fully ignite. It tries to ignite over and over again. I see a single blue flame for a short time, but not main...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
