 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman Furnace Troubleshooting?
I have a goodman furnace model # gmh80703ancb it is only 3 years old. The unit itself works great but the blower isn't working. Is there something I can do to check it before calling to get it serviced? Its getting cold, please help
|
||||
|
||||
|
There is a blower relay that could be the problem ($5.00), the t-stat, or a bad fan motor-either locked-up bearings or burned out windings. You need a meter to check anything except whether the motor is locked-up. To check that turn off power to furnace and see if fan turns freely. If not, replace motor ($40-50). The blower assembly slides out and unplugs. You can slide it out and test it with a meter. DrTom4444
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My goodman furnace/ heat pump will not turn on when I turn on at AC the unit outside will turn on but the blower will not. There trouble shooting light is not on.
Goodman 95% 2 stage furnace. LED code says pressure switch is stuck open. 1) Changed switch. 2) Jumped Limit switch. 3) Changed PCB. Same error code. 3 blinks "code says pressure switch is stuck open" Can You Guide me further
I put a new board in a GMP070 and the inducing fan motor kicks as normal, then the HSI starts to light but the whole board goes dead within 3 seconds.
The flame sensor keep burning out and only run for a couple of minute . Maybe the condensation trap is fully of dirt
I went away for a couple of days and returned to a cold house. I have a Goodman Model HCC075ND4R that has Electronic Ignition with Relay + VR80204 - S8600H Control. I can not get it to fully ignite. It tries to ignite over and over again. I see a single blue flame for a short time, but not main...
View more questions Search
|
