 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Nordyne Gas Furnace will run 2-3 minutes and 1 hr lock up sometimes
Since the new Nordyne Gas Furnace was installed 1.5 to 2 years ago and will sometimes run 2-3 minutes and then 1 hr lock up. If I reset the heat to off and wait about 3 sec. Then turn back on it does the same short heating cycle.
Sometimes it seems to only run 2-3 minutes and lock out for an hour all night, and then in the AM if I reset several times it will run for and hour or so and heat until the house is completely warm. It will then seem to run in a good cycle for a while (between a few hours to a number of days) and then it does it all over again. I have replaced the Thermostat from the most expensive Honeywell Digital (tried 2 of these) to one of the cheapest at Lowe's with no brain. The furnace is only a about 2 years old and has always had this issue on heat. AC works fine. Help! |
||||
Check out some similar questions!
My furnace will run all day and night but it blows cool air, house won't get above 58? Do I need to clean something? Should I just call a tech and have them do it? Thanks J
I have a Bryant Plus 90 furnace that has operated well for years. Last Monday the outside temp dropped to 3 degrees... I woke due to shivering and realized that the furnace was not operating. I checked all the fuses and everything else I could think of and when I replace the skins the furnace...
Status flashed three times replaced ignitor and control board. Still won't stay lite
When the furnace starts it will run for a few minutes then flame out . Then I have to reset the burner
I have A Nordyne Gas furnace in my home, work up this morning to a cold house. I can't find my manual to troubleshoot the problem. Status light is blinking twice. I can get furnace to work by by-passing the pressure switch w/jumper wire. Could the problem be the Combustion blower assembly. This...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
