 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Fireplace pilot is on but cannot get the burner on
I bough an old house has a fireplace with ITT millivolt valve. The pilot light stays on but cannot get the fireplace burner on. The thermopile voltage is 600 mv. Is it too low? There are four screw terminals on the valve. How do I tell which terminal for thermopile or wall switch? Does the red or white wire of thermopile needed to hooked up certain way? Do I need jumper by the way wall switch terminal and thermopile terminal. Any schematic or suggestion?
|
||||
Check out some similar questions!
I have a ventless fireplace, when I light the pilot and try to turn it to the on position it goes out, can you help with this much information
Hi, I have a lennox gas based fire place, the pilot is staying on but when I switch the unit on from the wall switch, it does not turn on. Any idea how to fix it ? Thanks
Hi all. I've got my pilot to light no problem. Then I turn gas knob to "on" as per instructions. I "adjust" switch on thermostat on wall only to hear clicking noise coming from inside panel of fireplace but the main burner doesn't light (like it used to last winter). I believe it's the main...
I have a 12 year old firplace that starts fine with the pilot but goes out after 15 or so minutes... as soon as it gets hot. I went on line and most of the advice was the same... to change the thermopile. I changed this and have the same problem. Now sometimes the burner won't turn on the same as...
My gas fireplace was working fine and then it turned off and the pilot is out. We don't know what happened or how to get it started again. Any help would be greatly appreciated. Of course, I can't find the paperwork that came with unit at this time. Unit runs on natural gas which runs under our...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
