 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman Furnace fan runs all the time
I have a Goodman GMP125-5 that runs all the time even with the thermostat off and the fan to auto. The only way to stop it is to turn off the power to the unit. I have done the following.
Circuit board LED blinking 4 times so I tested the overlimit switches. All are in closed and in testing the overlimit circuit from the board to the gas valve it showed a closed circuit on my VOM. Tested the pressure valve by turning the power to the unit on so the inducer motor would start and the pressure value switch closed. I assume this switch is "open" when the motor is off and "closed" once the inducer motor comes on and creates enough pressure on the valve. I feel I have eliminated both the overlimit safety (closed circuit) and the pressure switch (closes once the inducer motor is on) as issues so why do I still get 4 flashes on the LED? Any ides on what I should check next? Is there any way to test the circuit board? |
||||
Check out some similar questions!
My Goodman furnace sometimes starts up, vent fan, then the gas does not ignite or even appear, then blower runs through its cycle and shuts off, blowing unheated air around. It does this about 30% of the time now. A HVAC pal filed off the igniter rod saying it was corroded. He said there was...
I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...
The fan runs all the time but the unit never lights or heats. Where are the limit swithches that might need to be re-set?
I have a furnace that the fan runs all the time. The thermostat doesn't turn it off or doesn't seem to control the unit. The green lights on the board are on and the orange light is not. The unit will not fire up. I have unplugged and plugged in all connection. Didn't see any problems with...
Our New Gibson Furnace blower fan and draft inducer fan started running all the time no matter if the stat is on or off even unhooked the stat and still runs. The light on the circuit board is flashing a code 1. Does anyone have any experience with these furnaces and this problem? Thank You
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
