Ask Experts Questions for FREE Help !
Ask
    Jofrcu's Avatar
    Jofrcu Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 20, 2011, 10:46 PM
    Goodman furnace will not stay on
    My furnace kicks on gas ignites for about 3-5 seconds and then shuts down. Any thoughts ?
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
     
    #2

    Dec 21, 2011, 01:32 AM
    Hi Jofrcu and welcome, my thoughts are start by cleaning or replacing flame sensor. If you search AMHD for Goodman furnace you'll get other suggestions. You can also look to the left of this page and find Similar Threads.

    Good luck and let me know how it goes.
    Jofrcu's Avatar
    Jofrcu Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 21, 2011, 09:32 AM
    Thank you parttime, that is exactly what I did. I'm not that familiar with HVAC so it took me a while to figure out where everything is. I removed the flame sensor, cleaned it up and the furnace appears to be working fine. The wife and kids are warm again. Thank you
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
     
    #4

    Dec 21, 2011, 10:50 AM
    Hi again Jofcu, that's great news and a lot cheaper than calling in a tech. good job

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman GMP100-3 Furnace won't Stay On. [ 14 Answers ]

Hello, I have a Goodman Furnace (model # GMP100-3). The furnace will not stay running. Here is the sequence of events for two different scenarios that are occurring. Scenario 1 1. Thermostat Calls for Heat 2. Inducer starts 3. Pressure switch closes 4. Heating element glows 5. Burners...

Goodman furnace won't stay on after warming up [ 1 Answers ]

Everything starts sometimes stops after a few minutes or few seconds. Tries to restart again. Starts Then shuts downs tries to restart again pretty much dead. The red light stays on does not flash, What could it be what do I need to check. Thank you Cherr

Goodman furnace comes on but won't stay lit [ 6 Answers ]

Hi my goodman furnace tries to lite but something cuts the gas right back off. Is that the gas regulator? And can I just replace the module on the front of it or do I have to replace the whole regulator? Thanks Brian

I have a goodman furnace that seems to not stay lit. [ 2 Answers ]

I found the same issue or question that was previously asked about a year ago regarding a goodman furnace not staying lit after it power cylcled off 2-3 times. I would like to see the response or answer that Junior________ received. (sorry didn't catch the full name of the asker)

Goodman Furnace won't stay running [ 3 Answers ]

I have a goodman furnace that won't stay on.. the glow plug comes on and ignites the heat box, it will run then shut off... after it gets to desried heat,, then when you try to get it to run again it's like it shuts down after igniter being lit for about 10 secs, I've replaced batteries in...


View more questions Search