 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant 373lav024070
The red light flash 3 times. I set-up the thermostat to start the unit, first the air blower start running but the inducer motor won't start. I replaced the inducer motor and still not working and keep flashing 3 times. What should I do?
|
||||
Check out some similar questions!
I have a Bryant Plus 80 that is throwing a error of 33 (limit or flame roll out switch is open). The last time this happened was because the hot surface igniter was broken (frequent problem as my furnace has a tendency to short-cycle). I had picked up a couple extra ones so I had them on hand to...
Fan blower works but no heat. Is it the ignitor or flame sensor?
I think my blower motor is going and I can't find any numbers or info on it to get another. Anyone have any ideas?
Code 31 . The ignitor is taken out for replacement. The inducer moder does not start in the beginning. It starts after the 90 second blower motor runtime. What might have gone bad?
I have a bryant plus 80 series g furnace. Model 395CAV048111. My furnace will start a cycle but goes off. Then the led will flash 5 times, pause and then repeat the 5 flashes. Also, if I unplug the furnace it will reset and complete a cycyle, then it will start going off again. Any help would...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
