Ask Experts Questions for FREE Help !
Ask
    tsxxx's Avatar
    tsxxx Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 28, 2011, 05:14 PM
    Blower motor not coming on
    I have an older electric Colman furnace and the blower will not come on automatically anymore

Check out some similar questions!

Trane xv90 blower motor doesn't. Motor is free, unit is 7 years, not t-stat. Thanks [ 2 Answers ]

I believe I have troubleshot this down to either the blower motor or their Integrated Controller board. 120VAC to motor OK but too many other wires from board to motor for motor control to test (variable speed) without advice or a manual. Motor is rated for 100% duty cycle and has only been run...

Blower motor shaft not coming off the blowing wheel [ 0 Answers ]

Ok I tried everything I put liquid wrench in the shaft bolt holder thread , tap it with a piece of wood and hammer but the shaft not budging what else is there to do do I have to replace the whole unit

Gas coming on, but blower motor only running short cycles [ 7 Answers ]

I can see the burner igniting and the gas burning. Then a few seconds later the blower kicks in but kicks out shortly after coming on. Switched thermistat to on position and blower does the same thing instead of coming on running continuously? Unit just will not run long enough to heat the house....

Goodman furnace will ?heat motor? And blower motor will run but not at same time [ 2 Answers ]

I have a 2 year old Goodman, gas, no heat pump. There is a flashing LED that blinks once ever 4 seconds. Also, blower motor does not stay on always. We did smell something like an electrical burn. I'm guess my blower motor is fried?

Goodman AC/Furnace: condenser not coming on after installation of new blower motor [ 6 Answers ]

Have and outside Goodman AC unit and Goodman furnace (inside duh!). Anyhoo, after installing new blower motor the AC unit will not kick on. Have reset outside breaker, and double checking wiring on controller board on furnace, noticed one blue wire was disconnected, reconnected that and still not...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.