Ask Experts Questions for FREE Help !
Ask
    Dee_8080's Avatar
    Dee_8080 Posts: 5, Reputation: 1
    New Member
     
    #1

    Mar 27, 2011, 07:13 PM
    Blower motor shaft not coming off the blowing wheel
    Ok I tried everything I put liquid wrench in the shaft bolt holder thread , tap it with a piece of wood and hammer but the shaft not budging what else is there to do do I have to replace the whole unit

Check out some similar questions!

Cannot pull-out the blower wheel and motor assy from a Bryant HVAC [ 13 Answers ]

The blower wheel has a larger diameter than the opening of the air chamber. The blower wheel is damaged. Something inside the unit caused four of the vanes of the blower wheel to break off and jam the motor. This is a Bryant HVAC built in 2006. Has anyone else had this problem with an internal part...

Furnace blower wheel & hosing for philip motor. Who would have parts in Alberta Canad [ 1 Answers ]

We have a Hunter Wall funance with a new moter, but we need the Blower wheel and housing. Part # 421549-03 Philips Industries. Where could we get parts. We are from Alberta, Canada Thanks Gwen

Gas coming on, but blower motor only running short cycles [ 7 Answers ]

I can see the burner igniting and the gas burning. Then a few seconds later the blower kicks in but kicks out shortly after coming on. Switched thermistat to on position and blower does the same thing instead of coming on running continuously? Unit just will not run long enough to heat the house....

Squeaky Whirpool Gas Dryer motor, shaft or blower fan [ 1 Answers ]

Hello, The other day our whirpool gas dryer began making a loud squeaking noise that went away after using, at first. A few loads later the unit stop running, would restart briefly then stop again. After removing the panels and drum I isolated the noise to the motor. When spinning the shaft...

Goodman AC/Furnace: condenser not coming on after installation of new blower motor [ 6 Answers ]

Have and outside Goodman AC unit and Goodman furnace (inside duh!). Anyhoo, after installing new blower motor the AC unit will not kick on. Have reset outside breaker, and double checking wiring on controller board on furnace, noticed one blue wire was disconnected, reconnected that and still not...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.