Ask Experts Questions for FREE Help !
Ask
    den2pack495's Avatar
    den2pack495 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 27, 2011, 12:53 PM
    Williams gas valves
    I have a Williams wall furnace model # 1403612 it needs a new gas valve. The valve in the furnace is a Itt general TV27RA46 I have a new ITT General RA27RB37. They look Identical... the replacement for both valves is the same Replaces all TV27 series valves. Instead of spending 200.00 on a new valve will my other valve work?

    Thanks
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Nov 27, 2011, 04:56 PM
    If the replacement is the same it should work. I have watched techs strip out an old valve and replace it with another brand and it works. Regardless of the heater name, there are only a couple of valve manufacturers. I would be more careful of newer systems but for older units it seems to work well. Just be very careful with the gas and use plenty of pipe dope or Gas rated teflon tape. Let us know how it works please. Thanks, Brian
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

24 Volts and millivolts gas valves [ 1 Answers ]

How could I connect a 24 volts gas valve and a millivolts gas valve on separate units so they both shut shut down at the same time or ( connected in seriese or interlock to shut down both appliances at the same time new code in NYC)

Williams 10k wall heater, just installed, gets no gas to pilot. [ 6 Answers ]

.It's been sitting uninstalled for a year, then I installed it, it has gas going to the valve, but NO PILOT, and it seems no gas is coming to the pilot. 'Where do it begin priming or restarting a unit that's been sitting for awhile? It's still in new condition and barely ever used. Thanks...

My Williams Nat Gas Heater Pilot will not lit up [ 0 Answers ]

However hard I tried to keep the pilot knob pushed in, I cannot get the burner inside heater to lit up (forget staying lit - it does not lit up at all). This is just the second year with the heater - so quite brand new. Gas seems to be on, because I can get the heater working in a different room....

Gas valves [ 1 Answers ]

Ignitor is glowing red and gas is not igniting... blower is running and furnace is clean the service indicator light is a solid red light no blinking what could be my problem

I am thinking of installing a Natural Gas Williams Monterey Top-Vent Wall Furnace, wi [ 1 Answers ]

I am thinking of installing a Natural Gas Williams Monterey Top-Vent Wall Furnace, with 35,000 BTU In my finished basement. I have three heat registers but the temperature in the basement isn't as warm as we would like especially when its below freezing out. My question is, since the wall...

View more questions Search