Ask Experts Questions for FREE Help !
Ask
    bighappyman's Avatar
    bighappyman Posts: 3, Reputation: 1
    New Member
     
    #1

    Nov 14, 2011, 09:51 AM
    Husqvarna YTH2448 intek v-twin barely turns over despite new battery
    2005 Husqvarna YTH2248 riding mower w/ the BS intek vtwin 24hp engine will barely turn over (won't start) despite new battery. Sluggish. Will turn over a time or two and then stop. Tried jump-starting it off my truck with similar results. Any suggestions? Thanks.
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Nov 14, 2011, 11:06 AM
    Check valve clearance.
    bighappyman's Avatar
    bighappyman Posts: 3, Reputation: 1
    New Member
     
    #3

    Nov 20, 2011, 09:38 AM
    Adjusted them to .004 with no improvement. Thanks.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Husqvarna yth2448 won't charge the battery [ 1 Answers ]

The regulator burnt up so I replaced it, I can jump start it, but the blades only stay engaged for a few minutes and the voltage meter shows that it is not charging, also the battery is new, also the fuse is good

Husqvarna yth2448 riding mower electrical problems BS intek v twin 24 hp [ 1 Answers ]

Went to start it mid-chore and it didn't do anything. Turned key-- got nothing. Nada. Battery is good. Hour-meter isn't lighting. Headlamps don't come on. Checked (and replaced) seat sensor, solenoid, ignition switch, and PTO switch. Still nothing. Engine turns over fine when I bypass...

My Sears 18.5 lawn tractors barely turns over with new battery. Smoke from starter. [ 12 Answers ]

My Sears 18.5 HP tractor barely turns over with a new battery. I believe it could be the Starter. I saw smoke coming from it when I tried to start it. If It is the starter would I Need to buy the whole thing?

Problems with husqvarna yth2448 [ 6 Answers ]

My mower stops cutting on its own, and will not start cutting again until started up again only to stop cutting again a few minutes later.:confused: :mad: :


View more questions Search