Ask Experts Questions for FREE Help !
Ask
    bigewhat's Avatar
    bigewhat Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 19, 2011, 06:16 PM
    94 Ranger 2.3 Won't start
    My 94 2.3 will not start. Coils changed,plugs changed... no check engine light on. Been running rough here and there, sometimes worse than others. Sometimes I would have to hold the key till it started so I just changed the crank position sensor and it cranks better but will not start
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Nov 19, 2011, 08:52 PM
    Victory is close. Replace the Ignition Control Module (ICM). I recommend replacing them every 120,000 miles or 10 years, whichever comes first. They are problematic components. If the problem persists, change the Camshaft Position Sensor.
    bigewhat's Avatar
    bigewhat Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 20, 2011, 09:58 AM
    This model doesn't have the camshaft sensor, its not a California model
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Nov 20, 2011, 01:00 PM
    The problem is likely with the ICM, anyhow. I work off the information provided--sometimes, it's not the best to begin with.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

'97 toyota tercel won't start it turns the motor over but doesn't want to start? [ 3 Answers ]

I have checked fuel pump and changed spark plugs. I have know idea why it won't start or is hard to get started. When it does finally start it runs great so I think that would rule out the timing belt. If you have any suggestions I would appreciate it.

92 toy pu won't start after warmed up but will start with starting fluid? [ 1 Answers ]

Any suggestions

1991 frod ranger won't start [ 0 Answers ]

My ford ranger won't start starter gringing sometimes and sometimes it just spins. I have already replaced the flywheel and starter.

94 Ford Ranger won't start. [ 2 Answers ]

I have a 1994 Ford Ranger XLT 2.3 Liter. While driving a few days ago the engine stopped and would not start again. The next day I checked and one of the spark plug wires was split in half... don't know how! I replaced the wire and checked the others and the plugs, but it still won't start. ...

92 ranger won't start [ 2 Answers ]

I have a 92 ford ranger with a 4 cylinder Distributorless ignition. It has gotten to where it just cranks and doesn't fire. Changed plugs and wires and still nothing. Any easy way to check the coil packs to see if they are bad? Or what else could it be?

View more questions Search