Ask Experts Questions for FREE Help !
Ask
    poorboy21's Avatar
    poorboy21 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 9, 2011, 09:48 PM
    ?How do I properly bond gas and water lines?
    I ran a ground wire from a ground rod to the water and gas line... the inspector didn't pass it... what am I doing wrong?
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    Nov 10, 2011, 04:32 AM
    Why did you run this ground wire?
    What size service do you have?
    Is the water pipe metallic for at least 10' where it goes under ground?

    If you give us some more detail as to what you are actually doing it will help us help you.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water and gas lines bonding [ 0 Answers ]

Do I have to take bare copper #4 wire from mobile pedestal outside to the gas and water lines and the breaker panel inside the house? Or just bond the water and gas lines to the outside pedestal?

Cost to remove/replace galvanized water lines in walls with copper lines. [ 3 Answers ]

The long water lines have been replaced under the house, but not the lines in the wall. What would the cost be for kitchen, 1 full and one 3/4 bath?

My ruud gas furnace is not cycling properly [ 0 Answers ]

During day seems fine at night won't maintain temp over @62 deg F

Attaching properly gas flex pipe to gas pipe and gas stove [ 5 Answers ]

How do I properly attach the flex pipe to the gas stove on one end and the supply pipe on the other end? Do I need a gas poxy? If so what is the proper method of application--on both sides of the attachments (flex pipe and gas supply pipe/stove) or on just one, how much is enough? How tight do I...

View more questions Search