 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
York Diamond 80 blowing cold air...
Like the title says it's blowing cold air. However the small troubleshooting sticker on the inside of the lower panel gives a list of possible problems IF the LED is blinking. Mine is not blinking (or illuminated for that matter). Also the unit constantly runs and the only way to shut it off is by unplugging the unit. Usually this is remedied by the thermostat but it doesn't do anything when turned to off. My initial thought is the thermostat. Suggestions? Thanks for all help.
-Mike |
||||
Check out some similar questions!
Hi All... Hopefully uou can help me out... I have a york diamond 80 gas furnace. It was working fine up until a few days ago.. It began to blow out cold air when the house clearly was not even close to "requested" temp. It turns on, starts the initial motor, the humidifer also kicks...
Make : YORK Deluxe DiamoD (2 stage) Model : P1DUC20N09601B (My unit is 5-7 year old we change are HVAC to new when we did edition to are home) I have issue with my YORK. Some time fan continue work after heat stop (it take some time 1-1.5hr) and then it stop. I call service who instal my...
Hello, Our Diamond 80 furnace blows cold air when thermostat is set on 69F. So far I have cleaned flame sensor, replaced control board, limit switch and air pressure switch. The flame is coming on and works fine (no codes either). The first floor still gets somewhat warm air but the warm air...
I have York diamond 80 furnace. It is about 12 years old and works fine. Except one problem happens intermittently. Once a day or a few days, the furnace blows hot air. Once it reachs the set temperature, it will not stop and keep blowing hot air and then Change into room temperature air. Turning...
York Diamond 80 Furnace Blowing Cold Air. About five years old. Red light is flashing four times.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
