Ask Experts Questions for FREE Help !
Ask
    irishpride114's Avatar
    irishpride114 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 20, 2011, 09:13 PM
    Furnace turns off/on once the furnace reaches room temp.
    A couple of months ago in May or June, my furnace started turning its self off then turning back on (when turning on the draft blower motor would make a loud noise). We had a HVAC family friend and inspect. He said to disconnect the draft blower and worry about it when it gets cold again (its now cold). Well today I went out and replaced the draft motor blower assembly with a OEM motor assembly. Well once heater started (all flames were blue)it rose the temp. Of the house to the correct temp. After the burners turned off, followed by the blower, it started doing the samething again, except with no noise (new draft blower assembly). It only does this once the thermostat turns the furnace off. Ie as long as the thermostat thinks the house is to cold there is no problems. Though when I just went down to turn the furnace off at the breaker box, it did smell weird almost like a burning smell, not like gas in anyway.

    My furnace is says:

    Tempstar
    High Efficiency SP80
    (on front of furnace)

    On sticker inside:

    Innercity Products
    Model# NUG5100BFB2

    We replaced the old thermostat in April or May I think.

    Honeywell Thermostat
    Model # RTH6350D1000

    Sorry for the gaps, it was when I was remodeled the house.

Check out some similar questions!

XB80 Gas Furnace , furnace fires up fan turns on but no airflow in ducts [ 0 Answers ]

Furnace fires up just fine, and fan spins but there is absolutely no airflow in duct work. Any ideas? Last spring thermostat went out and I replaced it, worked great. A month later circuit board burned out, tech found that problem and replaced it (major pocketbook ouch) and everything worked...

Electric house furnace won't shut off when I when it reaches the temp set at [ 1 Answers ]

When it reaches its temp the fan won't shut off

Carrier furnace turns off before target temp, then right back on [ 23 Answers ]

I have a approx. 6 year old Carrier 58STA110 natural gas furnace. The blower motor and circuit board was replaced last year. I have installed a new digital thermostat, and the problem is still happening. The filter is new. No return vents are blocked. There is no signal of an error on the...

My heater furnace blower comes back on after it reaches a set temp [ 3 Answers ]

My heater furnace blower comes back on after it reaches a set temp. In oither words after it gets to set temp it chuts off then a few minutes later it comes back on for a minute than chuts off again.

Furnace cycles but never reaches set temp [ 1 Answers ]

I have a gas furnace and a daypart thermostat. The heat level never rises above or below 64 degrees, even though the temperature is set for 72 during the day. This started about 1 week ago. I have replaced batteries in the thermostat, replaced filters - and even replaced the whole thermostat. ...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.