 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Its not the flame sensor, or is it?
Upon turning on the thermostat for the first time this fall, the furnace did not start up. I've summarized below what specifically is happening, the error codes I've received and the steps I've attempted. I am not sure what to try next to resolve this. Thanks in advance for your advice/tips.
Details of Problem HSI lights, gas flows through all 4 burners and ignites, HSI dims and gas shuts off, flame out. After 3 attempts, the red LED light flashes 4 times. Steps I've taken Cleaned flame sensor- retested - no fix Replaced flame sensor with generic part (not an exact match) - retested - no fix Cleaned all 4 gas burners - retested - no fix Re-positioned sensor to be fully engulfed in flame - retested - no fix Details of Furnace and Parts Olsen H/E gas furnace -G95V060-3 - installed in 2008 Flame sensor (original) ICP model 1380687 (replaced with generic sensor - no product details) All wiring and connections appear "as installed" with no obvious signs of breaks/disconnections. |
||||
Check out some similar questions!
I have a weatherking furnace with a honeywell s9201a control board that I think is bad. I bought an upgraded control board 62-24084-82 that requires a flame sensor 62-24044-71 be added to the furnace. The flame sensor comes with the hardware to be installed on an inshot burner or a ribbon burner...
Being three days away from getting a new flame sensor, can the two broken pieces of the old flame sensor be effectively welded together? (rod is broken right behind ceramic insulator)
What does the flame sensor look like and where is it located?
I have a RHEEM furnace with a hot surface ignitor. The flame sensor will only register .01 microamps, not enough to keep the burners fired. What is the procedure for checking polarity for the furnace, and what could other possible causes be? The flame sensor is new, and the gas pressure is 3.5...
How can I replace a flame sensor in a Trane heating unit?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
