Ask Experts Questions for FREE Help !
Ask
    guitarlos's Avatar
    guitarlos Posts: 3, Reputation: 1
    New Member
     
    #1

    Oct 6, 2011, 03:41 PM
    What makes a furnace venter pressure switch close?
    My furnace will not come on. The LED flashes 3 times, which tells me the venter is plugged or my pressure stch is open. I bypassed the pressure switch and everything works fine. I installed a new pressure switch and the furnace came on as normal and the LED stayed on as it is meant to. I put the covers bck on the furnace. Te next evening I turn the furnace on and the same thing happened... LED blinks 3 times... pressure switch not closing... I can bypass it again and fuace works. Any suggestion?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
     
    #2

    Oct 6, 2011, 06:40 PM
    The inducer motor(vent motor) closes the pressure switch. It checks to make sure your vent is not restricted. On a 90% furnace if the exhaust vent, intake or condensate drain is restricted the switch will not close. NEVER BYPASS A Safety SWITCH. Give more info about your system if you can.
    guitarlos's Avatar
    guitarlos Posts: 3, Reputation: 1
    New Member
     
    #3

    Oct 6, 2011, 08:12 PM
    I just had a new condensate pump installed. That's when my problem stated. Is it possible that the drain was not properly connected?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Evcon Furnace 3 Flashes Combustion Air Switch Failed to Close. How Do I Repair It? [ 2 Answers ]

Evcon Central Furnace fault light flashes 3 times, combustion air switch failed to close, how do I make repairs?

Intertherm gas furnace diagnostic code reports "pressure switch stuck on close" [ 0 Answers ]

So furnace won't fire up. What the heck makes a pressure switch get stuck on close? Why doesn't blowing through the tube open it? Can hear a "click" so the diaphragm is doing something when I blow through the tube. I put the thermostat on "heat" and nothing at all happens(draft inducer does not...

Coleman evcon furnace pressure switch failed to close [ 3 Answers ]

My Coleman Evcon furnace will not heat. I took off the cover and saw a red light flash three times indicating pressure switch failed to close. I blew into both ends of the rubber tube. I noticed a click as I blew in the direction of the pressure switch and another click as I ceased blowing. ...

York residential furnace pressure switch problem code stuck switch [ 1 Answers ]

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

The Open Pressure Switch did not close. [ 1 Answers ]

The Open Pressure Switch did not close, how can I locate the switch to resolve the problem? Also the unit is a York system.


View more questions Search