Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Hot water problem - faulty check valve or mixing valve?
[ 8 Answers ]
Hi, We have a weird problem with hot water running cold in our apartment. At all of the faucets and taps we only get hot water for a minute or two and have to turn off the faucet/tap for 30 seconds and back on again to get hot water. Then the same thing happens again. To get continuous hot...
I'd like to install a ball valve on main water line will a "Viperlok" valve work?
[ 1 Answers ]
I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....
Cold water pressure relief valve leaking, not the TRP valve
[ 5 Answers ]
Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help.
Can I solder outlet side of a ball valve if the valve is closed and under pressure?
[ 0 Answers ]
Can I solder outlet side of a ball valve if the valve is closed and under pressure?
Can't identify brand type stem valve to shower
[ 14 Answers ]
Can someone possibly identify the make of my stem valve.. . most likely the original in a house built in 1960. My cold water valve leaks through the shower head. The brass is broken & cracked all around the rubber seal at the end so replacing the seals doesn't help. I thought it was a... View more questions Search
|