Bryant 394GAD, pilot lighting

twoleos617 Posts: 1, Reputation: 1

New Member

Sep 28, 2011, 10:44 AM

Bryant 394GAD, pilot lighting

I have a Bryant 394GAD, Series F, with a Honeywell VR8200H valve.
My air is blowing cold. Don't see a pilot light but blower is working. Does the pilot self light when out or do I need to light it? Filter is new.

Check out some similar questions!

Pilot is lighting on home heater but no hot air and pilot is lighting but it continue [ 0 Answers ]

Here is my problem The hot air is not coming out from a/c ven Heat was working two days ago Pilot works but it starts then goes out or low then starts again but gas to burner doesn't start main burners for heater Tried circuit breaker and on/off switch and pilot screw adjust which did not...

Lighting the pilot light on a bryant 75-347 unit heater [ 3 Answers ]

I have a bryant unit heater in my garage it is a 60,000 BTU model 75-347. The fan will run but I don't know how to light the pilot light.

Bryant 394GAD Vent Safety Switch Trips [ 1 Answers ]

I have a Bryant 394GAD that runs fine for days, then begins to have issues with the Vent Shut Safety Switch tripping and shutting down the flame. The fan continues to run and blow cold air throughout the house. If I reset the switch, the burners will come back on and the furnace will run. ...

Bryant 394GAD Pilot [ 1 Answers ]

Unit seems to work fine (heat & air). Noticed pilot was out recently, relit and was fine for several days. Noticed it was blowing cold air again and noticed pilot out again. Relit, burner ignites fine and cycles on and off fine (pilot remains lit). After a couple of days, pilot out again. Same...

View more questions Search

Check out some similar questions!

Add your answer here.