Ask Experts Questions for FREE Help !
Ask
    Jamin2day's Avatar
    Jamin2day Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 13, 2007, 08:17 AM
    Bryant 394GAD Pilot
    Unit seems to work fine (heat & air). Noticed pilot was out recently, relit and was fine for several days. Noticed it was blowing cold air again and noticed pilot out again. Relit, burner ignites fine and cycles on and off fine (pilot remains lit). After a couple of days, pilot out again. Same situation, relit fine, cycles on and off fine. Using Honeywell VR800 gas valve. Thermocouple for pilot seems OK (usually fail open, not intermittent failure). Suggestion?
    hixton's Avatar
    hixton Posts: 146, Reputation: 5
    Junior Member
    		  
    #2

    Nov 13, 2007, 05:58 PM
    Is your pilot burning hard or is the flame lazy and yellow if its lazy and yellow you need to clean it or have it cleaned
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Bryant-burners won't stay on. [ 1 Answers ]

I have a Bryant Model 397H. Have had an intermitent problem for the past 3 years. Furnace starts normally, burners come on and in about 5 seconds go off. This can repeat two to three times before remaining on and running normally. I have had two repairmen out to look at it and both times it would...

Bryant furnace does not come on [ 3 Answers ]

We have central AC/Heating with separate Bryant heating and AC units that are controlled from the same thermostat in the house. When I turn the Heat ON and set Temp to way higher than current Temp, the light on the thermostat comes on but the heating unit does not go on... no sound of burners...

Carrier vs Bryant [ 2 Answers ]

I have two quotes from two reputable installers. One quotes Bryant and the other Carrier. Both units are the second from the top level of the lines for scroll compressors and Puron. (Bryand Model 165a 5 ton versus Carrier Performance Series 5 Ton) The Bryant is being quoted a bit cheaper than the...

Bryant Burner [ 3 Answers ]

I have a valve on a Bryant Burner for an old gas furnace. There seems to be a problem with the gas valve that feeds the burner. Are 40 year old valves available? Thank you. Dennis

View more questions Search