Ask Experts Questions for FREE Help !
Ask
    skjch's Avatar
    skjch Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 28, 2011, 01:25 PM
    What should the pressure be on a ruud home a/c system?
    What should the high and low pressure be on a ruud system, about 25 years old.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Aug 28, 2011, 04:04 PM
    Depends on the inside temp, outside temp, size of unit, seer rating of unit, etc, etc, etc. There is no set pressure reading, as it will vary greatly depending on these factors and more.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ruud Zephyr has pressure switch open code (2 blinks) [ 0 Answers ]

Hello, I have a Ruud Zephyr furnace and it keeps turning off after only about 2 minutes of running. I replaced all of the filters and cleaned the flame sensor. The furnace runs OK for 2 minutes, then clicking begins on the board somewhere and the furnace shuts off. Can someone help me?

Boost home water pressure after filter system [ 0 Answers ]

Good morning~~ I am on a well... 32 p.s.I at pressure tank.water goes into a small 3/4" inlet sears canister {wool-spun cartridge} filter.. then into water softener.. out of softener... And into same style canister filter {charcoal cartridge}... pressure is not terrible in upstairs shower etc......

Ruud heating air condition system troubleshooting [ 1 Answers ]

Ihave replace ablower motor from a gas heater to electric heat the gas blower come from a ruud made in aug. 1996 I would some help on how to have the heating elements come on then the blower working off the thermostat now I do it with the breakers Ineed to know how I get elements to work ...

Home watter pressure system switch [ 2 Answers ]

I replace the watter pressure switch after repairs of a pump. Now I'm not able to sett the kick in and shut off limits (it's the one with manual shutoff lever and two adjusting nuts). Thank you Mark

How do I increase H2O pressure on well system with a water filtration system? [ 2 Answers ]

Howdy, I would like to know how I can increase my water pressure. My current system uses a well pump with a small pressure tank, and "D" control valve. It then runs through a WATERSOFT filtration tank, RAINSOFT water softner, and on the Hot water side, an AQUASTAR on demand hot water system. I...

View more questions Search