 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Ruud Zephyr has pressure switch open code (2 blinks)
Hello, I have a Ruud Zephyr furnace and it keeps turning off after only about 2 minutes of running. I replaced all of the filters and cleaned the flame sensor. The furnace runs OK for 2 minutes, then clicking begins on the board somewhere and the furnace shuts off. Can someone help me?
|
||||
Check out some similar questions!
I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...
I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals
Tried replacing the pressure switch does not help, have a child and ill wife help
Furnace - Amana GUIA115A40 Control board - White-Rodgers 50A50-298 My furnace just has the fans running non-stop and the control board is flashing an open limit switch error code. The furnace is getting good circulation and both fans seems to run fine. I cut power to it all night, in the...
How do I fix this? 2 blinks - pressure switch is on... :confused:
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
