 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
This is always a somewhat difficult task. The bigger the tile, the harder the job. I'll guess this is in a bath or shower enclosure-yes? The coefficient of adhesion must be higher than the pull of gravity, basically the weight of the tile. There is no quick and easy fix. I use Acryl Pro, put it on the Hardie per the tiling instructions regarding what trowel notches to use, set the tiles firmly and then use a padded support to hold them in place for a couple of hours. You can usually set about 4-5 lineal ft.this way. If you are very accurate with layout and cutting, you can work from both ends but constantly measure and adjust so your last tile fits. Make sure all the tile is well set and then grout, another messy job since it always falls down on you. Take your time, let set well and you should be able to do this job.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My basement bathroom ceiling is very low (7ft), especially over the shower/tub area. As a result, I am installing ceramic tile on the ceiling because of the moisture thing. I'm already using the same 12x12 ceramic tile on the floor and walls. This tile is recommended for floor or walls. I...
I will be installing ceramic tile (8X12) on a sheetrock ceiling above my tub.
My question is if anyone has any suggestions on how to get 20"x20" tiles to adhere and hold themselves to the ceiling using un-modified thinset mortar. Thanks for any help!
I am putting tile on the ceiling bathroom tub area. I am putting a 2X2 tile ceiling in, is there a specific adhesive to use or just the regular tile adhesive? How do you keep it up before it cures?
How do you apply ceramic tile to a ceiling in a shower stall?
View more questions Search
|
