Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Installation of a new thermostat
[ 1 Answers ]
I replaced my old White Rogers Heat pump thermostat model number 8848 E7 with a new Digital Hunter Just Right digital thermostat model number 42999B. I followed the directions from the diagram shown in the instructions for a 5-wire heat and cool system. I did the following. G to G, W to W, Y to Y...
New installation of thermostat
[ 3 Answers ]
I was wondering if any one would know to to reset a heater/cooling system? I just installed a new thermostat and I cannot get my heater/cooler to kick on and start. The last thermostat I had was a Honeywell T8401C and I just put in a Honeywell RTH230B. But the pilot light does not kick in to...
Thermostat Installation
[ 2 Answers ]
Hi How do I connect the thermostat ? 1) current wring consist of 2 feed and 2 load wires in the wall. The thermostat I want to install has 2 non polarized wires. How do I connect this? Do I connect the feeds to each other and then to the same wire on the back of the thermostat? Then Do...
Thermostat Installation
[ 2 Answers ]
I live in a Condo which has heating controlled by a boiler system which sends hot water through baseboards along the wall. I am trying to install a new thermostat because I think the previous owners installed an old, junky one right before they moved out and did it incorrectly. We now have...
Thermostat Installation
[ 3 Answers ]
I'm replacing my old heat pump thermostat(American Standard) with a Hunter Programmable Thermostat(Model 44360). I have seven wires coming in and they are all connected as follows: The white comes in and connects to a terminal labeled X2 and jumper goes up to the terminal labeled W. Green... View more questions Search
|