 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Vogue Impact Above Ground Pool
We had an oval Impact pool installed last year and we built a deck around one end and one side. We had 1/2 inch spacing between the top ledge of the pool and the decking boards, the deck did not touch the pool at any point. The pool was opened this spring, and the gap increased to over 1 inch on the end, and is now touching the entire side of the pool. The installer said that the pool probably settled, and that due to rough winter, may have pulled in a little bit. He said to not worry about it, and that I could cut the boards back on the deck. Question: does this happen normally, is there a possibility that it may collapse?
|
||||
Check out some similar questions!
We closed our pool about 6 weeks ago. I just discovered that 1/2 of the water has leaked out of the pool. I can't see any noticeable moisture around the pool. We also have a center drain. I have had the pool for several years so I know I closed and winterized the pool properly. Should I take...
I was wondering if I could use mulch to level the ground for my above ground pool. I was told not to use sand, and I have a hard time digging.
Do I go out further than pool size and how much do I dig out and how much sand do I use it's a 24 ft pool
Hello, the liner in part of my pool is below the water level and thus water is now behind the liner. I cannot pick up the liner because it is so heavy with the weight of the water. 1. Is this hurting my pool 2. How much to replace a new liner and have it installed for a 16ft round pool ...
We are going to install a new liner in an above ground pool this weekend. I have read conflicting information as to when the skimmer and jet holes should be cut. Do you fill the pool with water within a foot of the skimmer, attach the trim kit and then cut out the liner? I don't know what to do,...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
