Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Outdoor wall flush mounted box requirements
[ 1 Answers ]
I have a concrete block home with EMT pipe. I would like to install a flush-mounted outlet on an outdoor wall by passing a pipe from an adjacent indoor outlet. Can I use a standard EMT outlet box with a standard mudring followed by reapplication of stucco, paint, and a liquid-tight faceplate? ...
Wiring outdoor outlets
[ 3 Answers ]
I want to put in two outdoor outlets on my cabin. One on each end. 36 feet. The panel is one one end. From the one outlet to the other end I am going to drill holes in the floor joists. The cabin is off the ground three feet. It will be skirted. The question is... can I use NM cable or should I...
Outdoor wiring problem
[ 7 Answers ]
I plan to run power to my boat dock from my house. I will have two three way switches in the circuit so I can turn it on either from the dock or the house. The switches will control a light and a receptacle on the dock. I plan to use an underground type wire with three wires between the two...
Outdoor wiring
[ 1 Answers ]
What gauge wire should I use outdoors to install permanent electric boxes for a run of about 100 feet? The electric boxes would be for the use of Christmas lights and sidewalk security lights.
Conduit requirements for basement wiring
[ 1 Answers ]
I am finishing a basement with stud wall and dry wall. Is there any need for conduit to carry the wires behind the dry wall? I know for an unfinished basement wiring below grade must be in conduit but must it if the walls are finished? Thanks Dschaar View more questions Search
|