[restoren]

917.275021 23hp.48"craftsman/kohler rider.what do I torque the deck pulleys to?can't seem to find info any where.

[DG]

Good and tight.
I run them down as tight as I can with a 3/8 ratchet .haven't had any troubles so far .
Luck

[restoren]

Thanks a ton.
That confirms what I figured.just had to make sure.What I did was tightened it with the ratchet,then checked
The torque.It came out at about 55 LB's,so I torqued it down to about 64-65 LB's

Thank's again !

[ballengerb1]

Unless a manual specifies a torque on a nut or bolt there usually isn't one. Engine heads and auotomotives lugs have torques but most things do not. Like DG says, good and tight.

[restoren]

Thanks, that's good food for thought.
I'm kind of toying with the idea of a SM.side job cleaning,fixing,and saving decks/mowers from the farm fashionable,field ornament. Help pay for my fishen,any how. :)
My dad used to make knives,I sharpen ONE set of blades now I'm constantly getting bombed with the"help me's"
And of course on about 2% of them have any paper work ! That's why people like you are beyond awesome !

So again THANK YOU.