Ask Experts Questions for FREE Help !
Ask
    Mike_G's Avatar
    Mike_G Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 14, 2011, 03:53 PM
    Leak proof PVC to Cast Iron conections.
    I am trying to connect a PVC drain pipe to an existing 1930's cast iron pipe. There was considerable rust so I cut back the cast iron 1/4 inch and cleaned the threads and the interior of the pipe. I'm using a plastic beveled compression washer and nut (PVC), but can't seem to get a leak proof fit. Are there more flexible rubber washers I should be using or can I use some sort of waterproof putty or sealant that can fill the tiny gap that must be allowing the leak?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jun 14, 2011, 07:12 PM
    The original fitting probably had a bevel in it and by cutting off the 1/4", you lost the bevel. I would either try a Fernco adapter that would go over both pipes and then tighten the clamps or silicone a beveled PVC connection. You may be able to gob a silicone seal over the threads but personally I'd go with the Fernco. HD, Lowe's etc carry them.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to fix a leak on a copper x pvc x cast iron Tee? [ 2 Answers ]

Hi, I just wanted to know how to fix the leak on the Tee fitting going to my toilet. It is 1/2" copper X 2" pvc x 3.5" Cast iron Tee that feeds water to my toilet and sink, and collects waste from my Toilet and washer machine. I can't find this fitting anywhere on the computer, and my plumber said...

Cast iron vertical from cast iron horizontal can be pvc? [ 2 Answers ]

A leak developed in the main cast iron vertical stack of pipes leading to the horizontal main drain. Unfortunately, for me, the leak was so close to the ground that I had to break the concrete slab of the house. At that point, it just made sense to dig an extra 4 inches or so and remove the bad...

Replace sch 40 pvc to cast iron saddle 4 in pvc pipe broke [ 4 Answers ]

Replace sch 40 pvc into cast iron saddle with lead pvc pipe broke off even with lead packing what is the easiest way to remove pvc and lead to replace it

Cast Iron to PVC [ 1 Answers ]

Hello plumbing genius! I am new to the AskMe Helpdesk but I have read many of your other threads and it sounds like you know what you are talking about. I bought a money pit of a house made in 1959, and it seems like when I want to fix something pretty simple, it turns into a long and drawn out...

Cast Iron to PVC [ 5 Answers ]

We would like to put an offer on a house built in the 50's. It has cast iron plumbing and we possibly would like to change that to PVC throughout the house before remodeling. It is on a slab and a brick home. It is 2600 sq.ft. with 3 bathrooms. Is there anyway I can get a rough estimate on what...

View more questions Search