 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a 1999 integra gsr, the cel is on and when the codes were read they were dtc
Ihave a 99 integra gsr with the cel on. I had the codes read and it was dtc 1, 13. What can I do to fix the imedance of the map sensor? Should I just replace it? Also have the srs light on, srs code 1-3
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a 2007 Honda Civic EX with an aftermarket cold air intake. CEL comes on with codes for DTC P0171 (fuel system too lean). I just bought the car used, and I am not the one who installed the intake. Honda said they won't do anything because it isn't stock, and they will only troubleshoot it if...
Swap worked well and car ran great for 600 miles, then had 1 intermittent no spark/no start condition. After checking for spark, it then started... not sure why. Then the next time it was shut down, no more sparky or starty... Did k-test on MAP... good Tested Main Relay... good Ignition...
It's 94 integra gsr, driver's side low beam weak, has 11volts and high beams dead. Passenger's side bright on both low and high beams with a little over 12 volts. Is there a relay that controls the driver's side headlights?
I have a 1999 Ford Taurus SE. Motor runs great, transmission not working. Unplugged trans sensor and drove it but only had 2nd gear (I think) didn't shift at all. Check engine light on and I got these four codes. P1744, P0743, P0750, and P0760. Also Fuse 33 is dead. Any help would be great! Thanks....
^^^^
View more questions Search
|
