Ask Experts Questions for FREE Help !
Ask
    stk7105's Avatar
    stk7105 Posts: 1, Reputation: 1
    New Member
     
    #1

    May 31, 2011, 08:12 AM
    Bryant Plus 90 model 398A
    Hello -
    I have Byrant Plus 90 398A furnace.
    Lately, I noticed that my thermostat (Honeywell Chronotherm IV Plus) has no display. I am suspecting this maybe caused by blown furnace fuse. I took off the front cover of the furnace but could not find the fuse.

    Here's the picture ==> http://i283.photobucket.com/albums/kk300/stk7105/Furnace/Circuit.jpg

    Where is the fuse?

    Thanks in advance.

Check out some similar questions!

Bryant model 383k [ 1 Answers ]

My furnace burners cut on and off when calling for heat. The burner will first glow to light, than the burner will come on and five seconds later the burner will shut back off. It is almost like the furnace is short cycling. I did change the thermostat and the new thermostat is operating the unit...

Bryant model 2s to hunter model 44860 [ 1 Answers ]

I am trying to replace a bryant tstat with a hunter programmable tstat. The bryant is a single-speed heat pump with FK4 fan coil and special 3-stage electric heat (model 2s tstat) the hunter model is 44860 Assuming that it is a compatible tstat, is it easy to install? Thanks, ed

Bryant 90 plus 398A, only lights and heats when the burner compartment is open [ 5 Answers ]

The draft inducer starts, but pilot burner only clicks and lights when burner compartment cover is off.

Blower Bryant model [ 1 Answers ]

I have a Bryant furnace/air conditioning unit. The blower does not work. When the blower in turned on manual, the blower motor makes a humming noise but, the blower does not rotate. Can you assist in resolving the problem? Thanks


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.