Ask Experts Questions for FREE Help !
Ask
    barpeo's Avatar
    barpeo Posts: 1, Reputation: 1
    New Member
     
    #1

    May 26, 2011, 07:37 AM
    Sears troubleshooting tractor model 917255980?
    I have put new battery new key switch new solenoid. New amp gage check fuse and still no juice when I try to start it if I jump across the solenoid it will turn over but won't start
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
     
    #2

    May 26, 2011, 07:58 AM

    Did you check your wiring for continuity? Sounds like a wire may have broken. You will need a Multimeter to do that.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sears tractor model 917.254850 [ 2 Answers ]

I have a sear riding mower model # 917.254850 14 hp Kohler engine model CV14s Type#PS1452 and every time I turn the key to the cranking position it blows the fuse and won't start. I have checked all the wires and none are burnt or bare. Can some one please help I know its an old tractor but it...

Troubleshooting Sears Lawn Tractor [ 10 Answers ]

Troubleshooting Sears LT with a 17.5 2006 B&S Engine.Unit won't start. Isolated problem to fuel solenoid on bottom of carb. How is the solenoid wired into the system? Is there an interlock safety switch that might be the culprit?:confused:

Sears lawn tractor Model 917.273399 troubleshooting? [ 4 Answers ]

Blades do not disengage when I move the attachment clutch lever (there is a slack in the cable). I need to move the cutting deck up and down to get the blades to disengage. There is a lever (arm) under the Pulley, Mandrel that I can push by hand that causes the pulley to side forward and disengage...

Sears lawn tractor troubleshooting [ 1 Answers ]

I have a sears 917273170 tractor and I need to locate the interlock switches for the brake/clutch

Sears lawn tractor troubleshooting [ 0 Answers ]

I have a sear B&S lawn Tractor, It starts and Runs Fine as long as t I have the clucth pushed in. If I release the clutch or try to engage the blade, it dies. Even if it is in nuetral. Does anyone one know why.


View more questions Search