 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I cant get my 17hp craftsman (mo.917.270711)to turn
17hr.b&s.sears rider.mo.917.270711.I have to of the same mo.mowers.one is a doner mower and both ran fine electrecly and worked fine but was burning oil on one,so I swoped engines then all my problems started.First,stater burnt,no fire with the grond on coil,had to jump the selonoid from batt.to starter for it to turn but would not start. Changed wiring harness whit one I know works,new selonoied,changed egnition switch w/one that I know works.o yeah,new stater!I took off the safety switch from the pto to test it,but I don't know how.I do have a dm7c multimeter.please help. Slyme,
|
||||
Check out some similar questions!
I have a Craftsman 917.272751 Briggs 18 OHV Intek Plus. I have it for 10 years with no problems. This year I got 2 weekend grass cuttings in until the third cutting I was 45 minutes into the 2 hour event when the tractor sputtered, ran, sputtered, ran, sputtered, like some one took the fuel line...
Is there a drive pin in the drive shaft of this mower
Motor ran for a few seconds, it backfires every now an then, will kick over every now and then, also drags and locks up most of the time after you let off the starter. You have to manual roll back the engine then it rolls smooth, has good compression, hard to roll it through it. Cleaned carb...
Been searching but haven't found an answer to my problem. Craftsman twin 17hp rider Model 917.2559105 and has no spark. Found that I have a bad clutch switch so I jump that trying to get the engine started. Engine turns over fine but no spark to the plug, well sometimes it does and most of the time...
I was just given a lawn tractor- the previous owner says the drive starter is shot. Is this a common problem and how do I replace it?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
