Ask Experts Questions for FREE Help !
Ask
    DChondaracing's Avatar
    DChondaracing Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 17, 2011, 02:07 PM
    h22 vtec swap in my 92 prelude help
    I did the h22 vtec swap in my lude it will start when I pop start it but it won't start when I use the key when it starts it runs just fine will sit there and idle no problem and as soon as I shut it off it won't start until I pop start it again ne ideas
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Apr 17, 2011, 03:10 PM

    Remove and fully charge, or replace, the battery.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a h22 v-tec I'm going to swap my f22 out for [ 1 Answers ]

Will it hook up to all my stock wires clips

I have a 1991 honda accord non vtec and I want to put a f20 vtec engine. What I have [ 0 Answers ]

I want to put a f20 vtec engine in my 1991 non vtec honda accord. What more do I have to change for getting a better performance?

Does all vtec motors say vtec on top of motor [ 1 Answers ]

If the motor doesn't have to say vtec on the motor what am I looking for on a motor if it doesn't have to say vtech.thanks someone if I get an answer.you can email me [email protected] with an answer.thanks again:cool: :cool: :o ,if there is a number I must look for on the motor what letters or...

My 96 civic w/ 96 h22 won't start [ 10 Answers ]

I recently purchased this hatch with a 97 h22 a4 swap and it ran fine. Now just a few days ago I was driving down the road and the rpms dropped and the car shut off. I then waited a few min and I started it back up and it ran OK. I then drove it back to my house no problem. Well yesterday I drove...

92 honda hatch w/ ls vtec swap problems starting [ 1 Answers ]

Ok so I have a problem with the car not starting because I am not getting any spark... I have checked the distributer, and all the wires are measuring out right with the right readings... So what we were thinking that it might just be the ECU but I don't want to get a new one because I have been...

View more questions Search