Ask Experts Questions for FREE Help !
Ask
    victror's Avatar
    victror Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 12, 2011, 09:38 AM
    vinyl sliding doors
    How to remove vinyl sliding patio doors
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 12, 2011, 10:17 AM

    A brand name would be helpful. Most can be raised up and the pulled outword at the bottom to clear the track. A flat bar under the door between the door and the track may be required
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #3

    Apr 13, 2011, 09:07 AM

    As Bob stated a brand name would help.

    The outside door/stationary door would have to be removed first. Then the inside slider.

    Chuck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sliding glass doors [ 2 Answers ]

I recently replaced the old rollers with new rollers on a older sliding glass door. I had to take the frame apart (both sides and bottom) so I could get to the rollers. I had a really hard time putting the sides back on because the rubber gasket would not stay in place. Is there a trick to...

Sliding closet doors [ 2 Answers ]

Need to know how to put sliding closet door back onto track, is there a trick to it. I have tried everything:confused:

Sliding shower doors [ 1 Answers ]

I Need Step By Step Directions On Installing Sliding Shower Doors, I Think One Is Stationary.someone Took All The Frame Down And Now I Need To Put It Back Together, I'm Not Quite Sure How?

Sliding Barn Doors [ 4 Answers ]

I am going to build a double door for a barn that slides on channel. The will each be 6' wide and 12' tall. Any thing I need to know?

Old sliding glass doors [ 1 Answers ]

Hello all. I have a four panel sliding glass door from the 60’s The outside panels are fixed with the middle panels sliding. The doors are single glass. The frame channels are wide. Is there a way to replace the single glass with a thermal pane glass? Is this cost effective. I do...

View more questions Search