Ask Experts Questions for FREE Help !
Ask
    helpman777's Avatar
    helpman777 Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 12, 2011, 10:31 AM
    Low pressure on one valve only...
    I have on section of my sprinkler system that will only raise the 5 popup sprinklers on that section about halfway, and with only a little flow at each head. If I push down and 'seal' off two heads at one time, the others rise up all the way and then flow at full volume. I then can release the other 2 heads and they stay up and sprinkler normally as well. Unfortunately this does not help when using that section on a timer, as I have thus far been unable to train the squirrels and rabbits out there to sit on two heads and wait for the pressure to rise... what's the most likely problem? FYI, that section contains the lowest sprinkler head of the whole lawn, if that makes any difference.

Check out some similar questions!

Very low hot water pressure, moen 1 handle shower valve [ 13 Answers ]

I have a moen 1 handel shower valve. When I turn it on I have good cold pressure but hardly any hot pressure. I removed handle and turned stem all the way to hot but still I have low pressure. I tried to adjust scald guard but that is not the problem is there any other adjustment?

Why do I have low Water Pressure after diassembling diverter valve? [ 4 Answers ]

I disassembled diverter valve from Sprayer and Faucet (I wouldn't have had to from faucet) so that I could put a new holder for the sprayer on the sink. No other parts are new. And now I have low water pressure from both hot and cold. Should the diverter valve be replaced?

Cold water pressure relief valve leaking, not the TRP valve [ 5 Answers ]

Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help.

Can I solder outlet side of a ball valve if the valve is closed and under pressure? [ 0 Answers ]

Can I solder outlet side of a ball valve if the valve is closed and under pressure?

Low water pressure after turing main valve back on [ 1 Answers ]

I needed to turn the main water valve to the house off for a plumbing repair. Made the repair, turned the main valve back on and there is very little water pressure throughout the house. How do I restore the water back to the original water pressure?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.