Ask Experts Questions for FREE Help !
Ask
    buddy2623's Avatar
    buddy2623 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 26, 2011, 05:38 AM
    Pressure switch problems
    I have an Amana package unit. I have been told that Goodman owns Amana. This past December my heater stopped working. I could hear what I thought was the burner coming on but the fan would not come on. I contacted a repair company and after checking the unit, they told me that it was the pressure switch that was bad. I was told that it would cost $192.00 to replace the switch. I told them that it would have to wait.
    I found the switch in town and the part cost me $15.14 and about 20 minutes to install. As both electrical wires were the same color going to the switch, I positioned the wires so that I could get them put back on the correct terminals. The small hose could only go one place.

    The pressure switch is by Goodman and the part number is 11112501.

    Three months after replacing the switch, the heater went out again. I took the part back and was given another one at no charge. This time, it only lasted three weeks. I have ran the air conditioner and it works fine. What could be the problem with the heater portion of my package unit.

    If you can answer my question, will you send it to [email protected] ?

Check out some similar questions!

Carrier Gas Furnace, Pressure Switch Problems (Model 58MCA) CODE 31 [ 5 Answers ]

I have tried almost everything in my arsenal to try and diagnose the problem. First off I have a Carrier Gas Furnace that is almost 7 years old. Model 58MCA-80 (See attached photo for more information), with pressure switch #HK06NB123. Intermittently I get a Red Flashing Code #31 when the unit...

Well pressure switch problems [ 2 Answers ]

The 1/4' nipple going to the water well pressure switch became clogged with grit,what would be the best way to prevent this in the future. Thank You

York residential furnace pressure switch problem code stuck switch [ 1 Answers ]

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

Intertherm furnace pressure switch open problems [ 1 Answers ]

We have an intertherm furnace. The led light is blinking twice meaning that the pressure switch is open. We have replaced the pressure switch and are able to blow air through the attached tubes. They seem clear. The light continues to keep blinking.

More Problems . Pressure Switch Submersible Well [ 5 Answers ]

Hi - My pressure switch is short cycling or rapid cycling. Basically the points in the pressure switch are cutting on and off at a very, very rapid pace. Something is sure to be damaged soon. I had a plumber out the other day, but it would not do it when he was here. The pressure switch is...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.