Ask Experts Questions for FREE Help !
Ask
    dawn31981's Avatar
    dawn31981 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 2, 2010, 12:25 PM
    Intertherm furnace pressure switch open problems
    We have an intertherm furnace. The led light is blinking twice meaning that the pressure switch is open. We have replaced the pressure switch and are able to blow air through the attached tubes. They seem clear. The light continues to keep blinking.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jan 2, 2010, 02:42 PM
    Are all vents,supply and return open and clear? Is filter clean? Is it possible anything could be clogging the exhast vent? Does it have a clean a-coil?, this will keep you buisy for a while, get back to us

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Error code for "open pressure switch" on York natural gas furnace [ 6 Answers ]

I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...

Intertherm furnace pressure switch connections [ 4 Answers ]

Hi, I have a ~5yr old intertherm furnace whose lights indicate 'pressure switch stuck open'. I checked the hoses for blockage, and in doing so, can't be sure which hose went where.. (silly me).One hose, as you may know goes to the inducer through the backplate, and the other splits to the Gas valve...

Intertherm furnace pressure switch not working [ 3 Answers ]

Hi I have a intertherm furnace it is 2 years oid.The light on the panel is blinking twice.Wich says pressure switch open.HOw do I solve thise problem and get my furnace to work again.THANK YOU

Pressure switch stuck open on a tempstar furnace? [ 0 Answers ]

I have a Tempstar furnace that's reading a/an open pressure switch code. How do I correct this issue?

Pressure switch stuck open gibson furnace [ 3 Answers ]

I have a gibson forced hot air furnace and a have a code that is telling me that the pressure switch is open. If I drain the water out of it it will run for a short period.. Do you think I need a new pressure switch or do I have a drainage line clogged. Model number KG6R060C-12a


View more questions Search